Line / Trace Series Installation

Before installation, ensure that the selected surface is clean, flat, dry, and suitable for suction mounting. Check that all product parts are complete, including the suction base, shelf body, hooks, and related accessories. Proper installation is essential for stable use. Please follow the steps below carefully.

Step 1 — Clean Surface

Thoroughly clean the installation area to remove dust, grease, water, or any surface residue. Keep the wall completely dry before installation, as moisture or dirt may affect suction performance.

Clean the wall and keep it dry

Step 2 — Prepare Product

Assemble the product accessories as required and remove the protective cover from the suction cup. Make sure the suction surface is clean and free from debris before attaching it to the wall.

Prepare the product and remove the cover

Step 3 — Position & Apply Pressure

Place the suction base onto the desired position on the wall. Use either the palm of your hand or both thumbs to apply force, pressing the suction cup firmly and directly against the wall. Concentrating pressure at the center helps expel internal air and improves suction performance.

Use palm or thumbs to strongly press the suction cup

Step 4 — Check Pressing State

Check whether the suction cup is fully pressed and properly seated. The suction base should be fully compressed against the wall. If it remains un-pressed or there is a visible gap, press again or remove the product and reinstall it.

Check un-pressed and fully pressed suction state

Step 5 — Install Shelf Accessory

Attach the shelf body or hook accessory to the installed suction base according to the product structure. Slide or press the accessory into position and make sure it is properly fitted before use.

Install the shelf accessory onto the suction base
To maintain stable performance, check the suction state after installation and during regular use. If any loosening or instability is observed, remove the product and reinstall it before continuing use.