Before installation, ensure that the selected surface is clean, flat, and suitable for adhesive strips. Check that all product components are complete. Proper installation is essential to achieve optimal adhesive performance and weight-bearing stability. Please follow the steps below carefully.

Step 1 — Clean Surface

Thoroughly clean the installation area to remove any dust, grease, or moisture, and ensure the surface is completely dry. Any residue or dampness may severely affect the adhesive performance.

Step 2 — Prepare Product

Separate the individual strips (if applicable), then fasten them together in pairs by aligning and pressing them until you hear a click or feel them securely locked.

Step 3 — Attach to Frame

Tear off the liner from one side of the strips, attach them to the designated positions on the back of the frame, and press firmly to ensure full contact and a secure bond between the strips and the frame.

Step 4 — Position & Wall Alignment

Tear off the liners from the other side, and adjust the position and angle of the frame on the wall. Then, press the frame firmly against the wall to allow the strips to make initial contact with the surface.

Step 5 — Remove & Reinforce

Gently remove the frame from the wall (leaving one strip on the wall and its mate on the frame) to reinforce the adhesive. Press each strip left on the wall firmly from top to bottom for 30 seconds. Once done, wait 1 hour to allow the adhesive to fully cure and build maximum strength.

Step 6 — Reattach & Test

After waiting for 1 hour, align the strips on the frame with the strips on the wall, and press the frame firmly until each pair of strips is securely snapped and locked together. Ensure the product is firmly attached before regular use.