Bathroom Mirror Installation

Before installation, check that all product parts are complete, including the mirror, suction cup, connector, and shaving hook. Make sure the selected installation surface is clean, flat, dry, and suitable for suction mounting. Proper installation is required to ensure stable adhesion and secure use. Please follow the steps below carefully.

Step 1 — Attach the Connector

Press the connector upward into the bottom of the mirror until it is properly fitted. Ensure the connector is securely attached before proceeding to the next step.

Step 2 — Install the Shaving Hook

Buckle the shaving hook onto the connector. Make sure the hook is correctly aligned and firmly attached to the connector.

Step 3 — Clean Surface

Clean the wall thoroughly and keep it completely dry. Remove any dust, grease, water, or surface residue before installation, as moisture or dirt may affect suction performance.

Step 4 — Remove Suction Cup Cover

Remove the protective cover from the suction cup. Before attaching it to the wall, ensure the suction surface is clean and free from debris.

Step 5 — Position & Force Alignment

Place the mirror onto the desired position on the wall. Align the pressure point of your palm vertically with your shoulder so that your arm forms a straight force line toward the wall. This helps apply pressure more effectively during installation.

Step 6 — Apply Strong Pressure

Use your body strength to strongly press the suction cup onto the wall. Use both hands if needed to ensure enough pressure is applied and the suction cup fully contacts the wall surface.

Step 7 — Test Stability

After installation, pull down the mirror for inspection to ensure it is fully adhered and securely immobile. Do not use the mirror until it has passed the stability check.

Step 8 — Remove Mirror Protective Film

Tear off the protective film from the mirror surface after the mirror has been securely installed.